Cobble Loc with Grip

Cobble Loc is the newest technology in waterborne protection for concrete pavers, natural stone, stamped concrete, concrete surfaces and our TD One Step. 

Surfacelogix Cobble Loc is two-part, water based clear sealer designed to enhance and protect concrete pavers, natural stone, stamped concrete, and other concrete surfaces. Cobble Loc achieves an enhanced appearance like traditional solvent-based sealers, in an eco-friendly, low-VOC formulation. Cobble Loc protects surfaces, provides chemical resistance, locks down joint sands, and inhibits weed growth and anthills. Cobble Loc is available in multiple finishes and with or without a nonslip grip additive.

Cobble Loc is a concentrated two-part formula sold as a kit that requires mixing and dilution. A 1-gallon kit makes 2 gallons of sealer, 2.5-gallon kits makes 5 gallons, and 5-gallon kit makes 10 gallons.

FOR PROFESSIONAL USE ONLY

Product Directions

Surfaces must be clean and free of any contaminants before sealing. Concrete should cure a minimum of 28 days before sealing. On smoothly troweled concrete, an acid etch is recommend using muriatic acid.

Cobble Loc contains a part A and part B that must be mixed together. On pavers, dilute with one part water to one-part mixed sealer and apply with roller or sprayer.

For best results, it is recommended to mechanically mix with a power mixer for a minimum of 2 - 5 minutes.  Apply a uniform coat heavy enough to wet out joints if sand stabilization is desired. A second coat of sealer may be appropriate depending on the porosity of the substrate.

The 2nd coat can be applied after 4-6 hours of dry time. As a topcoat over Coloron, Colorcrete or TD One Step apply a uniform coat undiluted by water. To avoid buildup of sealer, do not apply Cobble Loc more than once every 2 years.

READ LABEL THOROUGHLY BEFORE APPLYING PRODUCT.

COBBLE LOC IS NOT RECOMMENDED ON SURFACES WHERE MOISTURE IS UNABLE TO DISSIPATE. 

FOR PROFESSIONAL USE ONLY